| Exit Panic Device |
| MP-8000
Series |
| Specification: Material: Push bar of aluminum extruded, steel pressed or stainless steel pressed and spring of stainless steel. Latch Bolt: 3/4" throw, stainless steel. Dead Latch Bolt: 5/8" stainless steel. Strike: For 5/8" stop, plus shim for 1/2" stop. Projection: 2-1/2" maximum, 1-7/8" pressed. Reversible: Non-handed, reversible for all functions and trims, except 80TP. For Door: 1-3/4" thick of wood or metal door. Specify thickness if other than 1-3/4". Backset: 2-3/4" Door Width: 3' standard for door width of 2'-6" to 3'-0"; 4' standard for door width of 3'-0" to 4'-0" Stile: 4-1/4" minimum. 2-1/4" for narrow stile. |
Mounting
Height: 40-5/16" from CL to finished floor recommended. Mounting: Furnished standard with sheet metal & machine screws or SNB as option. Cylinders: For trim, knob, lever & thumb-press type, "Schlage C" key way. Dogging: 1/4 turn, hex key dogging on non-fire labeled device. UL Listed: For "Panic Hardware" and "UL" Labelled (1-1/2hr) fire exit hardware. Operation: Inside by slight pressure on any point on the push bar at all time. Models: Rim type & vertical rod available. Trims as listed on next page. |
| Drawings & Dimensions |
| Rim type | Vertical rod type |
 |
 |
| Door Application Chart | |
 |
|
| A: For wood or metal door | N: For narrow stile offset | E: For narrow stile centered |
 |
 |
 |
| Trims Selection | |
 |
|
 |
|
| Strike Selection | Accessories |
 |
 |
 |
|